Thursday, May 18, 2023

Setting Bindings Back For Powder

Setting Bindings Back For Powder. 2) move both your front and back binding towards the tail. To do this, slide your bindings back from the reference points printed on the mounting holes an inch or so, so that you have more nose of the board in front of your bindings and less tail behind.

15 Best Snowboard Bindings Men's and Women's Pirates of
15 Best Snowboard Bindings Men's and Women's Pirates of from www.piratesofpowder.com

I usually move my bindings back one or two sets of holes. The other thing you can play with is the angle on your back binding, as bkrtron suggested. If you’re contemplating moving your bindings back for powder days, chances are you normally ride a twin stance, or close to twin.

To Do This, Slide Your Bindings Back From The Reference Points Printed On The Mounting Holes An Inch Or So, So That You Have More Nose Of The Board In Front Of Your Bindings And Less Tail Behind.


A larger setback stance is great if you are riding in deep powder. That would mean that the front binding is set at 24 degrees (positive stance angle) and the back binding is set at 9 degrees (also positive stance angle). If you have a channel set up (burton try 1 inch or 1 and a half inch increments (more of less).

This Is Because Your Weight Is At The Back Of The Board Which Assists With Keeping The Nose Up And Out Of Snow Allowing For Great Powder Float.


Finally, for skiers that plan on using a powder ski mainly in deep powder, you’ll also have the option of mounting your bindings even further back behind the traditional mounting point. Your front binding will be closer the centre of your snowboard (the waist) than your back binding. By moving up to three centimeters forward or backward from center, the skier can swap between riding in the park and floating in powder.

It Should Make A Lot Of Difference.


This will give you a stance width of 22” and a setback of 1.5”. Each notch is usually three degrees. Prepare 4 screws and 4 washers for each binding.

Setback Basically Means That Your Back Binding Will Be Set Up Closer To The Tail (Back) Of Your Snowboard Than Your Front Binding Is From The Nose (Front).


Setting the bindings towards the back of the board will create more lift in the front that will allow you to cut through and stay above the powder better. If you typically ride with your back foot angled the same as your front foot so you can ride switch, you can angle it back in closer to 0 degrees since you probably won’t be. Note there are numbers on the disk.

Bindings Mounted Further Back From The Center Help Achieve Those Goals.


Setting your back foot at zero is a great place to start as you experiment with the angle of your front binding and stance width. Positioning your bindings towards the tail of the board will help reduce fatigue when riding powder and in some cases help add energy and drive when initiating turns on hardpack. Set back stances are fun on powder days, but they aren’t as much fun on a groomed run.

Labels: , , ,

0 Comments:

Post a Comment

Subscribe to Post Comments [Atom]

<< Home