Electrostatic Fluidized Bed Powder Coating

Electrostatic Fluidized Bed Powder Coating. For most coating requirements powder is sprayed and charged electrostatically through spray guns onto the work piece. The heat activates the particles, causing them to fuse into a continuous coating.

China Electrostatic Fluidized Bed Powder Coating/Dipping from ourscoating.en.made-in-china.com

A fluidized bed is made up of a powder container and an air receiver that are separated by a porous fluidizing bottom. This method results in an even distribution and provides a protective layer of coating, but does require a greater. The heat of the powder melts the powder onto the parts which then becomes the coating.

Source: ourscoating.en.made-in-china.com

A primer is needed in some cases to get adhesion of the coating. To achieve this method, items are placed inside a fluidized bed and moved around while simultaneously being sprayed with a liquid.

Source: ourscoating.en.made-in-china.com

After this, the part goes into the oven and the powder is cured. The fluidized bed consists of two chambers separated bya specifically designed porous membrane plate which serves to uniformly diffuse air throughout the coating powder.

To Achieve This Method, Items Are Placed Inside A Fluidized Bed And Moved Around While Simultaneously Being Sprayed With A Liquid.

The parts are then preheated. Coatings range from 0.8 to 3 mils on relatively high speed lines. Charged particles of powder move.

Aeration Causes The Powder Particles To Become Suspended Into A Fluidlike Bath Of Turbulent Particles.

If you have the right configuration, fluidized bed coating can be the way to go. The hot parts are then immersed in an aerated bed of powder or fluid bed. When a preheated metal part is immersed into the tank, the powder particles melt and adhere to the surface.

Cm Provides Light Systems For Lab Work, To Higher Volume Systems.

What are some other benefits of fluidized bed powder coating? A fluidized bed is made up of a powder container and an air receiver that are separated by a porous fluidizing bottom. Creative method is a manufacturer of electrostatic powder coating systems used for the deposition of slot insulation powder in dc motor armature and stator cores.

It Generally Applies A Thin Coat Vs.

After this, the part goes into the oven and the powder is cured. An electrostatic charging media is placed inside the bed so that the powder material becomes charged as the fluidizing air lifts it up. 300x200 mm, height 260mmbase material acrylic 5mmfluidization plate:

For Most Coating Requirements Powder Is Sprayed And Charged Electrostatically Through Spray Guns Onto The Work Piece.

This causes the powder to adhere, melt, and fuse to the part. The heat of the powder melts the powder onto the parts which then becomes the coating. The first is where you heat the part and then run it through a fluidized bed.