Best Powder For Steel Shot

Best Powder For Steel Shot. From experience, steel 3’s and 4’s in 12 or 20 gauges seem to do the job quite well on pheasants and steel 6’s or 7’s are good for quail and woodcock hunting. The 3″ 20ga loads are much better for steel loading;

Alliant 410 Shotshell Powder 1 lbs Natchez from www.natchezss.com

The new special powder for waterfowl shotshell provides high steel shot speeds for 10 and 12 gauge loads within safe pressure limits. The 3″ 20ga loads are much better for steel loading; Ranger plus 1480 10800 1 steel 34 fed.

Source: www.natchezss.com

1/4 fiber under shot 1470 9500 1 Red dot burns quicker and has a little bit more recoil than green dot.

Source: www.natchezss.com

Do not exceed 1 pellet diameter over the height of this wad. Alliant steel is a powder for steel shot which is smokeless.

The New Special Powder For Waterfowl Shotshell Provides High Steel Shot Speeds For 10 And 12 Gauge Loads Within Safe Pressure Limits.

The powders i have used in the past to #4 gives 166 pellets in 7/8oz; Naturally, smaller shot sizes are best suited for ducks, while the larger shot is better for geese and swans.

Steel Shot Also Differs Substantially From Lead In Terms Of Weight.

I load on the slow end at about 1200 fps because speed is not necessary to smoke targets even with steel shot. Due to current lot of product this wad no longer holds 7/8 ounce of steel shot, you are still able to use the same load data for 7/8 ounce loads but you will only get 13/16 ounce (356 grains) of steel shot in this wad. Winchester makes the following recommendations when it comes to choose the right size shot, choke and choosing the proper yardage.

Special, New Powder For Waterfowl Shotshell Gives Steel Shot High Velocity Within Safe Pressure Limits For 10 And 12 Gauge Loads.

The best powder for any of these loads is alliant steel, followed by longshot. For handicap i use size 6 shot from bpi instead of 7s. To keep shipping costs to a minimum, powder and primers may be shipped together.

As To The Hand Weighing, I Did It That Way For A While, Then Found That If I Operate My Press And Charge Bar Correctly It Meters As Good As Any Large Flake Powder.

Alliant steel (1 and 4 lbs.) alliant steel was first introduced in 1998. Steel loads powder charge (grs) primer wad column velocity (fps) pressure (psi) steel 34 fed. Space for good consep counts for pellets and powder is tight for 2.75″.

Alliant Red Dot And Green Dot Powders Also Make Excellent Shotgun Reloading Powder.

Special, new powder for waterfowl shotshell gives steel shot high velocity within safe pressure limits for 10 and 12 gauge loads. Sam i 3 & one 20 ga. However, in the reloading supply shortage that existed before 2016 many folks had a.