Powder Coating Bullets Tumble Method

Powder Coating Bullets Tumble Method. I coat them very well with the powder and then bake them for 15 mins at 400 degrees in a cheap toaster oven from walmart( do not use an oven you will prepare food in). (smaller ones like.223 would be 100, larger ones like 45 acp 230’s might only be 30 at a time).

Powder Coating Cast Bullets (Dry Tumble Method from www.go2gbo.com

I place 3 or 4 pounds of bullets in a plastic container, add a teaspoon of powder and screw on the lid. I dump the bullets on a tray made of aluminium mesh. Then dump them into a different jug add half teaspoon moly, fill with hot water to cover bullets by about one inch, tumble for around 20 min and check.

Source: www.go2gbo.com

(smaller ones like.223 would be 100, larger ones like 45 acp 230’s might only be 30 at a time). If you have any data, photos, or any advice to add please share with us to help put the site together.

Source: www.go2gbo.com

If necessary i add a. The pc (powder coat) spray went everywhere and was a pain to clean up.

The Powder Coat Powder Does Not Stick To The Plastic Bucket And.

I first tumble a batch of bullets (around 200) in a jug with hot water and some dawn disk detergent, for about 15 min. Which is how i felt…at first. Im told some harbor freight powders wont stick i use the hb red and it works fine tks ken.

I Tried To Coat Some Tumble Type 124 Gr 9Mm Bullets And It Barely Is Sticking To It.

A lot of people who grew up and learned without it seem opposed to it; The powder coat bullets leave hard fouling at the beginning of the rifling and accuracy is 10 inches and larger at 25 yards from a rest. Modeling nonelectrostatic and electrostatic powder coating antoniewski m.

We Are Putting Together A Place Where People Can Come To Get Info On Powder Coating Of Cast Bullets.

The whole process is pretty easy, about the same effort as tumble lubing, but without the wait time for it to dry. (about 1/2″ deep) add between 30 to 100 bullets. Powder coating bullets does require more time than the traditional method of running bullets through a sizer/lubricator press.

Take Plastic #5 Container, Add Enough Air Soft Bb’s To Cover Bottom With 2 To 3 Layers.

Facing the daunting task of preparing a thousand.38 special bullets, i would rather run the bullets through a sizer/lubricator press or choose bullets that drop from a mould the correct diameter, roll the bullets in a liquid lube and allow them to dry. If you have any data, photos, or any advice to add please share with us to help put the site together. We will be testing different brands and methods to come up with the simplest, cheapest, and safest standards for pc bullet loading.

Adhesion In A Tumble Drum Process Cokro Setyo D.

Using powder coating on lead projectiles is fairly new (it has actually been around a lot longer than people realize but it has really begun to catch on recently. Then dump them into a different jug add half teaspoon moly, fill with hot water to cover bullets by about one inch, tumble for around 20 min and check. I coat them very well with the powder and then bake them for 15 mins at 400 degrees in a cheap toaster oven from walmart( do not use an oven you will prepare food in).