Hi Tek Bullet Coating Powder

Hi Tek Bullet Coating Powder. Doing it only once would be a definite plus for using a powder coat method. It's not the lead bullet, it's the thin junk candy powder coating paint mixed with keytones solvents that those bullets are coated with that's the junk.

HiTek Coating Cast Bullets The Ballistic Assistant from www.theballisticassistant.com

The 45 swc don't have coating in the groove or where the nose joins the body of the bullet. Width full roll 1.60m & length full roll 200m description : The coating prevents lead to bore contact and virtually eliminates lead fouling and the smoke normally associated with traditional wax type lubricants.

Source: www.theballisticassistant.com

Information about hitek coated bullets. The dillion powder funnel was set up like i had on the.

Source: www.thereloadersnetwork.com

I'm using lee dies, small pistol primer brass, titegroup and bayou 230 grn. Initial testing has proven the polymer coated bullets to be more accurate with a dramatic decrease in smoke.

Price Should Go Down From What He Posted But Don't Know For Sure.

Hi tek is faster to apply, less finicky to apply correctly. This was using the same size oven, baskets, etc. I have shot it with full bore 357 mag loads out of 18” barrels with no leading at all.

So I Have Been Loading For Just Under A Year On My 550.

Width full roll 1.60m & length full roll 200m description : The coating prevents lead to bore contact and virtually eliminates lead fouling and the smoke normally associated with traditional wax type lubricants. The 45rn microgroove bullets got a first coat of red/copper and the second coat of the blue/green.

Information About Hitek Coated Bullets.

This coating has been used down under for some 20 years, but has only been used in the u.s. Powder coat melts when you heat it up. This will help us to expedite your order.

The Dillion Powder Funnel Was Set Up Like I Had On The.

Many people prefer the powder coating because they've never tried hi tek. With the ht coating just dump the coated boolits on the mesh screen, let dry, into the oven, bake, recoat, and then size. If you do low volumes of cast bullets either method will work but if you do any sort of volume hi tek is the way to go.

For Those Developing Armor For Vehicle, Aircraft, And Ships, Dyneema Hb2 From Dsm Dyneema Provides Ultimate Protection Against 7.62X51 Nato Ball And Ak47 Mild Steel Core Bullets.

Doing it only once would be a definite plus for using a powder coat method. The 45 swc don't have coating in the groove or where the nose joins the body of the bullet. Each time a thin coat.